NUVO Lighting 62-1773 Blink Pro Plus, 24W, 12 in. x 24in, Surface Mount LED, CCT Selectable, 90 CRI, 120/277V, Rectangular Shape

Yes. The 62-1773 is a dual-voltage fixture rated 120V/277V, so the same part number works on residential/light commercial 120V branch circuits and on 277V commercial lighting circuits. That lets a facility standardize one SKU across buildings with different distribution.

It is built as a ceiling surface mount fixture, not a lay-in troffer. The mounting method is ceiling, and it mounts to the deck or ceiling surface rather than resting in a 2x4 or 2x2 grid tee. For a grid ceiling you want a lay-in panel or a troffer; use the 62-1773 on hard-lid drywall, concrete, or plaster ceilings.

Indoor only, with a damp location rating. That covers enclosed bathrooms, laundry rooms, basements, and covered interior areas where condensation occurs. It is not rated for wet locations, so do not use it in an open exterior soffit, a direct-spray shower zone, or anywhere exposed to weather.

One SKU covers the color range: the 62-1773 is CCT selectable, so the color temperature is chosen at the fixture during install rather than by ordering a different part. That is what lets a property manager stock a single fixture and still match the existing color in each space. It also delivers 90 CRI, high enough for retail, healthcare, and anywhere color rendering is called out on the spec.

Dimmable, and output runs 1650 to 1900 lumens from 24 watts. The lumen spread tracks the selectable color temperature setting, so plan layouts on the low end if you want to be safe on footcandles. You will need a compatible LED dimmer on the circuit; the fixture itself has no integral control.

The light source is an integrated LED, so there is no lamp to change and no socket. At end of life the fixture is replaced, not relamped. Rated life is 50,000 hours, which is the number to use for maintenance planning in a facility on long burn hours.

It carries a cETLus safety listing, which covers both US and Canadian requirements, and the fixture is RoHS compliant. That is typically what an inspector or institutional spec is looking for on a commercial indoor luminaire.

Die-cast aluminum base with a white finish, which is the only finish offered on the 62-1773. Aluminum helps pull heat off the LED board, and it is an edge-lit panel design, so the light comes from the perimeter across the diffuser rather than from visible point sources.

Yes. Lead is identified as a CA Prop 65 chemical for this fixture, so a California job needs the warning carried through on the submittal and labeling.