NUVO Lighting 62-1783 Blink Pro Plus, 24W, 12 in. x 24in, Surface Mount LED, CCT Selectable, 90 CRI, Rectangular Shape

Yes. The Blink Pro Plus 62-1783 is a 120V/277V fixture, so the same part works on standard 120V branch circuits and on 277V commercial lighting circuits. That means one SKU covers both a leased office floor on 277 and a back-of-house area fed at 120, which is what makes it easy to standardize across a building.

It mounts directly to the ceiling surface, no cutout and no plenum depth required. The housing is only 1.06 inches high, so it sits nearly flush and works where there is no room above the deck, like a concrete ceiling, a corridor soffit, or a closet. Fixture footprint is 23.70 by 11.83 inches at 4.92 lbs.

Color temperature is selectable on the fixture itself, so you order one part number and set the CCT at install. That is the practical reason to spec it for a multi-building portfolio: you stock a single item and match whatever the adjacent spaces already run instead of carrying three or four separate color temperature SKUs.

It is damp location rated and indoor only, so a bathroom ceiling, a covered corridor, or a locker room is fine. Do not use it in a wet location, meaning anywhere subject to direct water, outdoors uncovered, or inside a shower enclosure where a wet-rated fixture is required.

It is cETLus listed, which is the ETL mark recognized for both the United States and Canada, so it satisfies the listed-equipment requirement an electrical inspector looks for on a commercial install. The fixture is also RoHS compliant.

The Blink Pro Plus 24W puts out 1650 to 1850 lumens depending on the color temperature selected, from a 12 x 24 inch luminous surface. That is a typical output for a corridor run, a restroom, a break area, or a small private office. For open office or retail sales floor levels you would lay out multiple units rather than rely on one.

The fixture is dimmable. The LED array is integrated, meaning the driver and boards are built in and there is no lamp to change, so dimming is handled by the fixture's own driver rather than by anything you swap in. Confirm the dimmer you are using is an LED-compatible control before you commit the floor.

At 90 CRI, colors render close to natural light, which matters in healthcare exam and patient areas, retail merchandise display, hospitality guest corridors, and anywhere finishes and skin tone need to look right. For a warehouse aisle or a mechanical room, a standard 80 CRI fixture does the job. Specs that call out high color rendering generally set 90 CRI as the threshold.

The body is die-cast aluminum, not stamped steel or plastic, which helps pull heat off the LED boards and stands up better to knocks in corridors and service areas. Rated life is 50,000 hours, and since the LED is integrated there is no relamping cycle to schedule, the fixture is replaced at end of life.

Black is the finish on the 62-1783. If you are matching a job where the other ceiling fixtures are white, this is the black-trim member of the Blink Pro Plus family, so pick the part number that carries the finish you need rather than assuming the 12 x 24 is offered in your color under this number.

Yes, lead is the listed chemical on the Prop 65 disclosure for the Blink Pro Plus 62-1783. Institutional and government procurement groups that require the notice on submittals should carry that forward on the package.