SATCO Lighting S12414 8W LED A19, Clear, Medium Base, 2700K, 90 CRI, 120V

Yes. The S12414 is an enclosed rated lamp, so it can go in a closed globe, jelly jar, or a sealed ceiling fixture without voiding the lamp. It also carries a wet location rating and is listed for indoor or outdoor use, which covers exterior porch and coach fixtures. Burning position is universal, so base up, base down, or horizontal all work.

Yes, the S12414 is a dimmable lamp. Worth noting it is not a three-way bulb, so it won't step through levels in a three-way socket the way a 30/70/100 incandescent does. If the fixture is on a three-way turn knob rather than a wall dimmer, this is the wrong lamp for it.

The S12414 has a clear glass lens over an LED filament, so you see the filament strands the way you would in a vintage style incandescent. That's what you want in an open pendant, a sconce with no shade, or a chandelier where the bulb is part of the look. In a bare fixture at eye level the filament is a visible point source and can glare, so a frosted or milky A19 is the better call there. Beam spread is 320 degrees, so light goes nearly all the way around rather than being thrown one direction.

2700K is warm white, the same yellow-toned color as a classic incandescent, so it reads as soft and residential rather than office white. The 90 CRI rating means colors render close to how they look under natural light, which matters in hospitality lobbies and guest rooms, retail, and anywhere finishes, wood tone, or skin tone need to look correct. Most commodity LED A19s sit at 80 CRI. Color is fixed at 2700K, not field selectable.

Each S12414 draws 0.067 amps at 120 volts. Even derating a 15 amp circuit to the 12 amp continuous load allowance, the lamp current itself is a non-issue in any realistic fixture count. Watch the fixture and dimmer ratings instead, since a dimmer's minimum load and its LED lamp count limit are usually what caps a run, not the branch circuit.

Rated average life is 15,000 hours. Against a typical 1,000 hour 60 watt incandescent, that's a large reduction in relamping trips, which is the real cost in a multi-family building, a hotel, or a facility where a lift or a ladder is involved. At roughly 3 hours a day it works out near 13 years of service.

No. The S12414 is not DLC approved, so it won't qualify under a rebate program that requires a DesignLights Consortium listing. If a rebate is driving the spec, that requirement has to be checked before you standardize on this lamp. It is FCC compliant and is stated as lawful for sale in California.

Yes. It's rated for wet locations and listed for both indoor and outdoor use, so open-bottom post lights and porch fixtures exposed to rain are within its rating. Because it's also enclosed rated, sealed lantern-style fixtures are covered too. Standard 120 volt medium base, so no adapter or driver is needed.

Construction is aluminum and glass, with a glass lens. That's a real glass envelope, not a plastic diffuser, so it holds up to heat and cleaning but will break if it's dropped or struck. For a tenant-accessible fixture in a hallway, stairwell, or laundry room where the bulb can get knocked, a plastic-lensed A19 takes abuse better. For sconces, pendants, and enclosed exterior fixtures out of reach, glass is fine and looks better.

Satco S12414. It's a single configuration lamp, offered only in the clear finish, so there's no finish or color temperature choice to specify when ordering. Every S12414 is 8W, A19, medium base, 2700K, 90 CRI, 800 lumens, 120V.