SATCO Lighting S12416 8W LED A19, Clear, Medium Base, 3500K, 90 CRI, 120V

Yes. The S12416 is an enclosed rated lamp, so it can go in closed globes, jelly jars, and sealed ceiling fixtures where a non-enclosed-rated LED would cook itself and fail early. It also carries a wet location rating and is listed for indoor and outdoor use, which covers covered entries, porches, and exterior sconces.

Yes, it dims. It is not a three-way lamp, though, so it won't step through low/medium/high in a 3-way socket the way a 30/70/100 incandescent does. If your fixtures are on 3-way sockets rather than a wall dimmer, this is the wrong lamp for that behavior.

3500K is neutral white, between the warm 2700K of a standard soft white incandescent and the cooler 4000K used in shops and garages. It reads clean and slightly crisp rather than yellow, which is why it's a common pick for corridors, lobbies, offices, and rental turns. The 90 CRI rating means colors, skin tones, and paint finishes render close to how they look under daylight, well above the 80 CRI of a typical builder-grade LED.

Clear glass with a visible LED filament. That means the light source is exposed, so it belongs in fixtures where you want the filament look, or in shades and diffusers. In a bare open socket at eye level, a clear filament lamp is far more glary than a frosted A19, so pick frosted for exposed fixtures in occupied rooms.

Any orientation works. The S12416 is rated for universal burning position, so base up in a can or ceiling pan, base down in a pendant, or horizontal in a sconce or wall bracket all run the same. No derating and no orientation restriction to track when you're specifying across mixed fixture types in a building.

320 degrees. That is near-omnidirectional, close to how an incandescent A19 throws light, so it fills a shade or a globe evenly instead of dumping everything downward the way a directional LED does. It's the reason a filament lamp works in chandeliers, ceiling fans, and open glass fixtures where the bulb is seen from all sides.

15,000 hours average rated life. On a common-area fixture burning about 12 hours a day, that works out to roughly 3.4 years between relamps, which is what makes these worth the swap in stairwells and hallways where the labor to reach the fixture costs more than the lamp.

It runs on line voltage, 120V at 60Hz, drawing 0.067A. Straight into the existing socket with no driver, transformer, or ballast, and no ballast bypass to do. If your fixture still has a fluorescent ballast or is a low voltage system, this is not the lamp for it.

Fixed at 3500K. There is no CCT selectable switch on the lamp, so every one you install produces the same neutral white with no chance of a field tech setting one fixture to 2700K and the next to 4000K. For a property manager standardizing a building, that consistency is the point, but it also means you order the color you want up front.

Aluminum and glass construction, with a glass lens rather than a plastic diffuser. Glass holds its clarity over time instead of yellowing the way some plastic covers do, but it also means the lamp breaks if dropped, which is worth knowing before you hand a case to a crew relamping high fixtures from a ladder.