You may also like
SATCO Lighting S29407 6.5W, PAR20 LED, 3500K, 40 degree Beam Angle, Medium Base, 120V
6.5 Watt - PAR20 LED - 3500K - 40 deg. Beam Angle - Medium base - 120 Volt
Manufacturer Resources
Spec Sheet
Product Specs
- Amps:
- 0.054A
- Avg Rated Hours:
- 25000
- Burning Position:
- Universal
- CA Web Text:
- California T24 Listed
- CCT Selectable:
- No
- CRI:
- 90
- DLC Approved:
- No
- Dimmable:
- Yes
- Enclosure Rating:
- Enclosed Rated Lamp
- FCC Compliant:
- Yes
- Housing Color:
- Silver
- Lamp Base:
- Medium
- Lamp Filament:
- LED
- Lamp Shape:
- PAR20
- Lens Finish:
- Clear
- Lens Material:
- Thermo Plastic (PBT)
- Lensed:
- Yes
- Lumens:
- 520L
- Operating Frequency:
- 60Hz
- Product Type:
- PAR
- Subcategory:
- LED
- Technology:
- LED
- Three-Way:
- No
- Warranty:
- 3 Year Limited - 12 hr per day
- Product Group:
- Indoor Lighting
- Product Subgroup:
- Light Bulbs
- Incandescent Equivalent:
- 50W
- Location Rating:
- Wet
- Base Material:
- Plastic
- Location Indoor/ Outdoor:
- Indoor;Outdoor
- Product Voltage:
- 120V
- Beam Spread Angle:
- 40
- Light Temperature:
- 3500K
- Product Category:
- Light Bulbs
- Product Wattage:
- 6.5W
- Product Material:
- Plastic
- Product Weight:
- 0.13 lb
Satco Lighting S29407 – Frequently Asked Questions
1) Can the Satco S29407 PAR20 LED go in a sealed or enclosed recessed can?
Yes. The S29407 is an enclosed rated lamp, so it can run in a sealed fixture or a closed recessed can without the heat shortening its life. It is also wet location rated, which covers it for exterior soffits, eaves and open porch cans.
2) Will this Satco PAR20 LED work on my existing dimmer?
The 6.5W S29407 PAR20 is dimmable, but it draws only 0.054A at 120V. Old incandescent dimmers often have a minimum load far above that, so on a single-lamp circuit you may see flicker or drop-out at the low end. On a multi-lamp run or an LED-rated dimmer it behaves normally.
3) Will 3500K match the other bulbs in my building?
The S29407 is a fixed 3500K neutral white, not color selectable, so it will match other 3500K lamps and will read slightly cooler than 3000K and noticeably warmer than 4000K. At 90 CRI it renders color well enough for retail, hospitality and healthcare spaces. If your other fixtures are 3000K, these will stand out side by side.
4) Is a 40 degree beam angle right for general recessed downlighting or should I use a narrower spot?
40 degrees is a flood beam. It is the right pick for general ceiling downlighting, corridors, and even wall coverage where you do not want scalloped hot spots. If you are accenting artwork, signage, or a merchandise display and want a tight pool of light, choose a narrower PAR20 spot instead.
5) Can I use this Satco PAR20 LED in a three-way lamp socket?
No. The S29407 is not a three-way lamp, so in a three-way socket it will only operate at one output level rather than stepping. For three-way table and floor lamps you need a lamp specifically built with a three-way base.
6) Does the Satco S29407 meet California Title 24 requirements?
It is California T24 listed. It is not DLC approved, so if your utility rebate program requires a DLC listing, this lamp will not qualify for it.
7) Does it matter whether this bulb is installed base-up or base-down?
No. Burning position is universal, so base-up in a recessed can, base-down in a pendant, or horizontal in a wall sconce all work the same. That is useful when you are standardizing one lamp across mixed fixture types in a building.
8) How long will these last before maintenance has to swap them again?
Rated at 25,000 average hours. On a 12-hour-a-day commercial schedule that is roughly five and a half years of service, which is why MRO and property buyers spec LED PAR20s over 50W halogens that need changing every year.
9) What does the bulb look like installed, clear lens or frosted?
Clear lens over a silver housing, with the lens in thermoplastic PBT rather than glass. Clear gives you a defined beam edge with a visible source; if you want the LED array hidden and a softer face, pick a frosted PAR20 instead.
How fast can I get the Satco Lighting S29407 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Satco Lighting S29407 come with a warranty?
Absolutely. The Satco Lighting S29407 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Satco Lighting S29407?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Satco Lighting S29407 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.