You may also like
SATCO Lighting S29436 12.5W, PAR30LN LED, 3000K, 60 degree Beam Angle, Medium Base, 120V
12.5 Watt - PAR30LN LED - 3000K - 60 deg. Beam Angle - Medium base - 120 Volt
Manufacturer Resources
Spec Sheet
Product Specs
- Amps:
- 0.104A
- Avg Rated Hours:
- 25000
- Burning Position:
- Universal
- CA Web Text:
- California T24 Listed
- CCT Selectable:
- No
- CRI:
- 90
- DLC Approved:
- No
- Dimmable:
- Yes
- Enclosure Rating:
- Enclosed Rated Lamp
- FCC Compliant:
- Yes
- Housing Color:
- Silver
- Lamp Base:
- Medium
- Lamp Filament:
- LED
- Lamp Shape:
- PAR30LN
- Lens Finish:
- Clear
- Lens Material:
- Thermo Plastic (PBT)
- Lensed:
- Yes
- Lumens:
- 1000L
- Operating Frequency:
- 60Hz
- Product Type:
- PAR
- Subcategory:
- LED
- Technology:
- LED
- Three-Way:
- No
- Warranty:
- 3 Year Limited - 12 hr per day
- Product Group:
- Indoor Lighting
- Product Subgroup:
- Light Bulbs
- Incandescent Equivalent:
- 75W
- Location Rating:
- Wet
- Base Material:
- Plastic
- Location Indoor/ Outdoor:
- Indoor;Outdoor
- Product Voltage:
- 120V
- Beam Spread Angle:
- 60
- Light Temperature:
- 3000K
- Product Category:
- Light Bulbs
- Product Wattage:
- 12.5W
- Product Weight:
- 0.35 lb
- Product Material:
- Plastic
Satco Lighting S29436 – Frequently Asked Questions
1) Can I use this LED PAR30 in a sealed or fully enclosed recessed fixture?
Yes. The S29436 is an enclosed rated lamp, so it can go in a sealed can or a closed fixture where heat builds up. Many LED PAR lamps are not, and running a non-enclosed-rated lamp in a sealed housing shortens its life. It also carries a wet location rating, so covered exterior soffits, canopies, and shower cans are all in scope.
2) Will the Satco S29436 dim on my existing incandescent dimmers?
The lamp is dimmable, but LED dimming performance depends on the control. Legacy incandescent (leading edge) dimmers were sized for a large resistive load, and at 0.104 amps per lamp a few LEDs on a circuit may fall below the dimmer's minimum load, which shows up as flicker, drop-out, or a dead bottom end. On a relamp job, put it on an LED-rated dimmer or keep enough lamps on the circuit to stay above the dimmer's minimum.
3) Is a 60 degree beam angle right for general recessed downlighting, or should I pick a narrower spot?
Sixty degrees is a flood pattern, meant for general room and corridor wash where cans are spaced on a grid and you want overlapping pools with no scalloping. If you are accenting artwork, retail merchandise, or a feature wall and want a tight defined pool, a narrower spot beam in the same PAR30LN shape is the better choice. The S29436 is the wide flood.
4) Is 3000K the right color for matching existing halogen downlights in a hotel or lobby?
3000K is warm white, the closest standard LED color to the look of halogen, so it blends with an existing halogen or 3000K LED installation. It reads warmer than 3500K or 4000K commercial white. CRI is 90, so skin tones, wood, and fabric render accurately, which matters in hospitality and retail. Note this is a fixed color lamp, not CCT selectable, so you order the 3000K specifically.
5) Does the Satco S29436 meet California Title 24 requirements?
Yes, the 12.5W PAR30LN is California T24 listed, which is what a spec on a California job will ask for on a residential or covered nonresidential relamp. It is not DLC listed, so if your utility rebate program requires DLC, this lamp will not qualify for it.
6) Can I put this outdoors under a soffit or in an exterior canopy?
Yes. The lamp is rated for both indoor and outdoor use and carries a wet location rating, so exterior soffit cans, canopies, and covered entries are fine. The lens is clear thermoplastic (PBT) with a silver housing.
7) Can this PAR30 be mounted base-up in a recessed can or does it have to point down?
Burning position is universal, so it runs base up in a recessed can, base down in a pendant or track head, or horizontal in a wall-wash or gimbal trim without any effect on its rating. Rated life is 25,000 hours.
8) Is the Satco S29436 a three-way bulb?
No. It is a single output 12.5W lamp, not three-way, so in a three-way socket it will run at one level only. For stepped output you need a lamp specifically built as three-way.
How fast can I get the Satco Lighting S29436 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Satco Lighting S29436 come with a warranty?
Absolutely. The Satco Lighting S29436 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Satco Lighting S29436?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Satco Lighting S29436 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.