Schaub 211093 4" Center to Center Monza Cabinet Pull

The Monza takes M4 metric machine screws, not the 8-32 threads common on domestic American cabinet hardware. If you are mixing this in with existing 8-32 pulls on the same run of cabinetry, keep the screws sorted, they will not interchange. Order screw lengths to suit your door or drawer front thickness.

Projection is 1-1/4 inches off the face with a 5/8 inch base dimension, which gives normal grip clearance behind the bar. In a tight galley or where a drawer bank sits opposite an appliance, that 1-1/4 inch stickout is the number to check against your clearance.

Four: Magenta (MA), Matte Black (MB), Matte Green (MG), and Signature Satin Brass (SSB). The matte black and satin brass read as standard kitchen and bath finishes, while magenta and matte green are color options for accent runs or a statement island.

The Monza is a contemporary aluminum cabinet pull, so it suits residential and light commercial casework, millwork, and unit kitchens. For heavy-traffic commercial drawer banks where the hardware takes abuse, a solid brass option such as the Deltana SBP35 heavy-duty square bar pull, or a Trimco 562 Series drawer pull (offered in 3-1/2 inch, 4 inch, and 96mm centers), matches the same 4 inch spacing family in a heavier material.

The Deltana SBP35 modern square bar pull is a 3-1/2 inch heavy-duty solid brass bar pull, a shorter spacing than the 4 inch centers of the Schaub 211093 Monza pull, which keeps a modern bar profile on narrower fronts. The Trimco 553 Series drawer pull is a 3 inch center-to-center option if you need to go smaller still. Both require their own drilling rather than reusing the 4 inch holes.

The Omnia 1970 modern cabinet pull is forged solid brass with a 1-1/4 inch projection, the same standoff from the door or drawer face as the Schaub 211093 Monza pull. If you need slightly less projection, the Omnia 1969 and Omnia 1971 are both forged solid brass at 1-3/16 inch projection.

The Deltana SBP35 modern square bar pull is described as heavy-duty solid brass, and the Omnia 1968/102, 1969, 1970 and 1971 pulls are forged solid brass. The Schaub 211093 Monza pull has an aluminum base material, which is lighter in hand. For commercial cabinetry that takes constant use, the forged or solid brass options give you a denser material, though you will need to confirm the center spacing matches your existing drilling.

The 211093 is the 4 inch center-to-center Monza pull, part of Schaub's Monza collection. For openings where a pull is wrong, such as small upper doors, a round knob like the Orca Bachelor Collection knob at 1-1/4 inch diameter or the square Blackcomb knob at 25mm covers the knob side of the job, though those are a different brand and finish family so match your finish carefully before mixing.