Schaub 217 8" Center to Center Northport Square Cabinet Pull

Yes. The Northport 217 is drilled on 8 inch center-to-center, so it drops onto cabinet or drawer fronts already bored at 8 inches without new holes. Overall length is 9 inches, which leaves about a half inch of pull past each screw hole, so check you have that much clear face on either side of the existing bores.

Zinc is the base material on the Northport 217, finished in one of eight plated or coated colors. If your spec calls for solid brass, look at the Omnia 1968, 1969, 1970 or 1971 modern cabinet pulls, which are forged solid brass, or the Deltana SBP35 square bar pull in solid brass.

The Schaub 217 Northport pull is a zinc-base cabinet pull with a 1-1/4 inch projection. If the specification calls for solid brass, the Omnia 1970 modern cabinet pull is a forged solid brass pull that also carries a 1-1/4 inch projection, so the standoff from the door face matches. Confirm the center-to-center you need, since the Schaub 217 is an 8 inch center-to-center pull and the Omnia is ordered by its own spacing options.

Projection is 1-1/4 inches, measured from the door or drawer face to the back of the grip. That is enough knuckle clearance for a gloved hand, and it matters on inset cabinetry or where a drawer sits next to a wall return or an appliance panel that could foul a deep pull.

Eight finishes: Satin Nickel, Brushed Nickel, Polished Nickel, Polished Chrome, Matte Black, Ancient Bronze, Brushed Bronze, and Signature Satin Brass. That spread covers most kitchen and bath schemes, and because Northport is a collection you can carry the same finish across knobs and shorter pulls in the range for a consistent look on a multi-unit or spec job.

The Schaub 217 is a square transitional pull, so a square knob keeps the profile consistent. The Orca Hardware Blackcomb collection square cabinet pull knob is a 25mm square knob. If you would rather break up the run with round knobs, the Orca Bachelor collection offers a 1-1/4 inch round knob and a 1-1/4 inch round ring knob, both of which match the 1-1/4 inch base dimension of the Schaub 217.

The Schaub 217 is a decorative zinc cabinet pull in a transitional square profile. For a heavier commercial or appliance look, the Orca Hardware CK-12001 is a steel T-pull bar with a 2 inch bar width in satin nickel, which is also one of the finishes the Schaub 217 is offered in. The Deltana SBP35 is described as a heavy-duty solid brass square bar pull if you want the square bar shape in brass.

Northport is a transitional square-profile pull, so the grip and posts read with flat faces and crisp edges rather than a round tube. If you want a round bar look instead, the Emtek Bar Cabinet Pull from the Schaub collection is the round-profile alternative, and the Orca CK-12001 T-pull bar is a steel bar-style option in satin nickel.

Yes, that is the usual approach: long pulls on drawers and appliance panels, knobs on upper doors. Northport is a collection, so matching pieces carry the same finish family. If you want a square knob to echo the Northport profile, the Orca Blackcomb square cabinet knob is 25mm; for round knobs the Orca Bachelor collection knobs are 1-1/4 inch diameter.

No. The SDC SP50 is a 50mm spindle used in door control hardware, not cabinet hardware. The Schaub 217 Northport pull mounts with 8/32 machine screws through the drawer or door face on 8 inch centers. Order replacement screws in the correct length for your face thickness rather than a door spindle.