Schaub 737 6" Center to Center Traditional Cabinet Pull

The 737 uses 8/32 thread screws, 1 inch long. That length suits a standard 3/4 inch face. If you are mounting through a thicker slab front, a 5-piece front with a thick panel, or through a backing panel, you'll need longer 8/32 machine screws.

The Omnia 1970 is a modern cabinet pull in forged solid brass with a 1-1/4 inch projection, the same standoff from the door or drawer face as the Schaub 737. The difference is purely styling and construction origin: the 737 is a traditional-style solid brass pull from the Traditional Designs collection, while the 1970 is drawn in a modern profile. If the cabinetry is contemporary and you still need the hand clearance a 1-1/4 inch projection gives, the 1970 carries it over.

The Schaub 737 is a 6 inch center-to-center pull with a 6-3/8 inch overall length, so it needs a drawer front wide enough to carry it. For narrow fronts, the Trimco 553 series drawer pull is 3 inch center-to-center, and the Trimco 562 series offers 3-1/2 inch, 4 inch, and 96mm center-to-center options. The Deltana SBP35 is another short option at 3-1/2 inch in solid brass. All three drill a different hole pattern than the 737, so plan the boring before you mix them on the same run.

Projection is 1-1/4 inches from the face of the door or drawer, which gives full-hand grip room, and the post base is 1/2 inch. On inset cabinets or anywhere a pull sits near a wall, appliance, or an adjacent door in a corner run, check that 1-1/4 inches of stand-off clears before you drill.

Twelve finishes: Polished Brass, Antique Brass, Antique Light Brass, Polished Chrome, Satin Nickel, Polished Nickel, Antique Nickel, Distressed Nickel, Oil Rubbed Bronze, Distressed Bronze, Michelangelo Bronze, and Flat Black. The 737 is part of Schaub's Traditional Designs collection, so if you are extending an existing job, ordering the same finish code from the same collection keeps knobs, pulls and appliance pulls consistent.

Solid brass is the base material, not die-cast zinc. For rental turns and multi-family work that matters because a brass post threads and re-threads without stripping the way a cast pot-metal pull does, and the finish is carried on a solid substrate rather than a thin shell over zinc.

No, those are not interchangeable. The Orca Hardware CK-15030 and CK-16030 are round cabinet knobs at 1-1/4 inch diameter, and the CK-17025 is a square knob at 25mm - all single-hole knobs. The Schaub 737 is a two-hole pull on 6 inch centers with an 8/32 thread x 1 inch long screw at each end. Swapping a knob onto a door already bored for the 737 leaves an open hole. Knobs are a reasonable choice for small doors; for existing 6 inch boring you need a pull on matching centers.

No handing to specify. It is a symmetrical two-post pull on 6 inch centers, so the only choice on the order is finish. That makes it straightforward to spec in volume for a multi-unit or hospitality job where every opening gets the same part.

The Omnia 1969 and Omnia 1971 are both modern forged solid brass cabinet pulls with a 1-3/16 inch projection, a hair tighter to the face than the 1-1/4 inch projection of the Schaub 737. The Omnia 1968/102 is a 4 inch center-to-center pull, so it drills differently from the 6 inch centers of the 737. All are solid brass like the 737; the visual difference is modern versus traditional styling.