Schlage L283-124 Coin Turn, L9040, L9044, 1-5/8" to 1-7/8" Doors

The L283-124 is a coin turn, the slotted outside turn piece that lets you unlock a privacy or bathroom mortise lock from the corridor side with a coin or flat screwdriver. It fits the Schlage L9040 and L9044 mortise functions, and it is sized for doors 1-5/8 to 1-7/8 inches thick. It is a replacement part, not a complete lock, so the lock body and the inside turn stay in the door.

Yes. The coin turn covers a 1-5/8 to 1-7/8 inch door thickness range, and 1-3/4 inches is the standard commercial door thickness that sits in the middle of it. If your opening is a thinner 1-3/8 inch door, this part is outside its range and you need a different thickness turn.

No. The coin turn is sold on its own as a replacement part for the L9040 and L9044, so you swap the outside turn piece and leave the mortise body, the inside turn, and the door prep alone. Match the finish to the rest of the trim on the door and the repair is done from the corridor side.

Just the outside coin turn piece. It is the small slotted trim that mounts in the outside rose of an L9040 or L9044, so the inside turn, the roses, the escutcheons or levers, and the mortise body all have to be there already. If your door is missing more than the turn, you are looking at a trim set or a complete mortise lock instead.

Yes, as long as the doors fall in the 1-5/8 to 1-7/8 inch thickness band and the locks are L9040 or L9044. That covers standard 1-3/4 inch commercial doors, which is what most restroom and patient-room openings use. Buy the turns in the one finish your building is standardized on and they become a shelf spare for any of those doors.

No. The coin turn is a round trim piece that rotates in either direction, so there is no left or right hand version. The two things that decide the order are door thickness, 1-5/8 to 1-7/8 inches, and the finish you need to match.