You may also like
Anchors 5/8 x 7 Wdg HDG (Box 10)
Manufacturer Resources
Product Specs
- Division:
- Electrical H1
- Pack Type:
- Box
- Product Group:
- Fasteners
- Sub Division:
- Electrical-E H2
- Department:
- Electrical
- Product Subgroup:
- Anchors
Metallics TS507G – Frequently Asked Questions
1) Can I use a 5/8 x 7 wedge anchor in block or brick instead of concrete?
No. Wedge anchors like the TS507G are for solid, poured concrete only. The wedge clip expands against a continuous hole wall, and hollow CMU or brick will crush or blow out instead of holding. For block, use a sleeve anchor or a screen tube and adhesive sized for hollow base material. In grout-filled block, that is still a different anchor decision than solid concrete.
2) Is the TS507G anchor rated for outdoor or wet locations?
It is hot-dip galvanized, which is the coating specified for exterior and damp concrete work: securing strut and standoffs on rooftops, pole and equipment bases, dock and ramp framing, parking structures. Plain zinc wedge anchors are the interior, dry-location version. If the base material is concrete and the anchor will see weather, the HDG version is the one to order.
3) What else do I need to install the TS507G wedge anchor?
A rotary hammer with a 5/8 inch carbide bit, a blow-out bulb or vacuum to clear the hole, and a wrench or impact to pull the nut up and set the wedge. The nut and washer are part of the anchor assembly on a wedge anchor, so no separate hardware is needed to clamp the fixture. Drive the anchor through the fixture hole until the washer sits flat, then torque the nut to set the clip.
4) How many anchors come in a box of Metallics TS507G?
Ten anchors per box. The pack type is a box, and it ships as a quantity of 10 of the 5/8 x 7 hot-dip galvanized wedge anchors, which is the usual count at this diameter, since 5/8 inch anchors go in at low quantities per base or bracket rather than by the hundred.
5) What is the Metallics part number for the 5/8 x 7 hot-dip galvanized wedge anchor?
TS507G is the Metallics part number, and it is also the manufacturer part number to quote on a purchase order. It identifies the 5/8 inch diameter by 7 inch hot-dip galvanized wedge anchor supplied in a box of 10.
How fast can I get the Metallics TS507G delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Metallics TS507G come with a warranty?
Absolutely. The Metallics TS507G is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Metallics TS507G?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Metallics TS507G from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.