B-Line B236RSS6 Eaton series strut fittings and accessories, 3.5" Height, 2.06" Length, 1.87" Width, .65lbs, Steel, Right hand three hole offset bent angle, 90 deg, Stainless steel type 316

Right hand. The B236RSS6 is a right hand three hole offset bent angle bent to 90 degrees, so the offset leg runs one way only. If your connection mirrors the other direction, you need the left hand version of the same fitting instead, not this one.

It is steel in a Type 316 stainless steel specification. Type 316 is the grade normally specified for wash-down, coastal, chemical, and wastewater environments where plain electro-galvanized fittings would corrode, so this is the fitting to use where a standard zinc-plated angle would not last.

Order it as B236RSS6, an Eaton B-Line series strut fitting. The RSS6 suffix is what identifies the Type 316 stainless version, so do not substitute a B236 without that suffix if the job calls for 316.

Use the offset version when the two strut runs do not meet in the same plane. The offset in the B236RSS6 steps the connection over so the channel faces line up without shimming, and the third hole gives you an extra fastening point along the longer leg. A plain flat 90 degree angle is the choice when both pieces of strut sit flush on the same surface.

Certifications are marked Not Applicable for this fitting. It is a mechanical strut angle rather than an electrically listed component, so specify it on material grade and geometry, 316 stainless in a three hole 90 degree offset, rather than on a listing mark.