B-Line B236LSS6 Eaton series strut fittings and accessories, 3.5" Height, 2.06" Length, 1.87" Width, .65lbs, Steel, Left hand three hole offset bent angle, 90 deg, Stainless steel type 316

The B236LSS6 is the left hand version of the three hole offset bent angle. Handing matters on an offset bent angle because the offset leg breaks to one side, so a right hand part will not mirror into the same position. If the offset needs to run the other direction off your strut, you need the right hand equivalent, not this one.

It is a steel fitting finished in stainless steel type 316. Type 316 is the marine and chemical grade stainless, so this is the fitting to use in wash-down areas, coastal installs, water treatment plants and food processing, where electro-galvanized or plain zinc strut hardware would rust out.

It is a 90 degree corner bracket with three bolt holes and a formed offset, used to tie two runs of strut channel together at a right angle where the two channels do not sit in the same plane. The offset takes up the step between the two surfaces so you are not shimming the joint. Three holes let you split the fastening between the two legs for a fixed, non-rotating corner.

Yes. The B236LSS6 is supplied as the bracket only, so channel nuts, bolts and washers are a separate line. For a 316 stainless install, keep the hardware in matching stainless - mixing plated carbon steel bolts into a 316 bracket in a wet or coastal environment gives you galvanic corrosion at the fastener.

Order it as Eaton B-Line B236LSS6. The LSS6 suffix is the left hand, stainless steel type 316 version of the B236 three hole offset bent angle, so quoting the full designation keeps you from getting the plain or electro-galvanized equivalent.