B-Line Eaton series strut fittings and accessories, 3.5" Height, 2.06" Length, 1.87" Width, .65lbs, Steel, Left hand three hole offset bent angle, 90

It's the left hand version. The B236LGRN is a left hand three hole offset bent angle bracket, bent to 90 degrees. Handing matters on an offset fitting because the offset leg steps to one side of the strut, so a right hand bracket mirrored into a left hand position won't land the bolt holes where you need them. If your layout puts the offset to the other side, order the right hand equivalent instead.

DURA GREEN is Eaton B-Line's green coating over the steel bracket, applied for corrosion protection rather than appearance. The base material is steel. For wash-down, exterior, or corrosive-atmosphere work, buyers typically compare it against plain electro-galvanized or hot dip galvanized versions of the same fitting, since the same three hole offset bent angle is built in several finishes.

It joins two runs of strut channel at 90 degrees where the two members don't sit in the same plane. The offset built into the bracket takes up that step, so you don't have to shim or field-bend anything. Three bolt holes let you split the fastening between the two legs. Typical use is racking conduit, cable tray supports, and equipment frames off a wall or an existing strut run.

The B236LGRN is sold as the steel bracket itself. Strut hardware, channel nuts and bolts, is ordered separately and sized to the channel you're bolting into, so add that to the order if you don't already have it on the truck.

Left and right hand offset angles are separate part numbers in the B-Line series. B236LGRN is the left hand, DURA GREEN version; the right hand runs under the corresponding B-Line number with the same finish suffix. If you're building symmetrical racks, count how many of each hand the layout calls for before ordering, since one hand won't substitute for the other.

Yes. It's an electrical-department strut fitting, used to bracket strut channel runs that carry conduit, cable tray, and light mechanical loads. The 90 degree offset bend makes it the piece to reach for when the branch run sits proud of the main run.