B-Line Eaton series wiring trough, 6" height, 12" length, 6" width, 4XSWT wiring trough, Welded external mounting feet, Hinged cover, 4X, 304 stainle

The 6612-4XSWT is a 6 x 6 inch trough body, 12 inches long. That gives you a 6 inch square wireway cross-section for conductor fill and bending space, in a 12 inch section you can gang with other lengths or bodies. Shipping weight is 9.475 lb.

It is built to NEMA 4X in 304 stainless steel with a seamless poured-in-place gasket, which is the construction used for wet, outdoor, and corrosive or washdown locations. The cover is hinged and held by semi-hinges, screw clamps and stainless hardware, so the seal is maintained by clamping pressure around the gasket.

Welded external mounting feet are part of the enclosure, so it bolts straight to a wall or strut with no separate bracket kit. Because the feet are external and welded, no fastener penetrates the trough body, which is what keeps the 4X rating intact once it is hung.

Hinged is the right pick where you will be back in the trough repeatedly, pulling, splicing, or tapping, since the cover stays captive on its semi-hinges instead of coming off in your hand on a ladder. Screw clamps still pull it down tight against the gasket for the 4X seal. If the trough gets opened once at install and never again, a screw cover is simpler; anything serviced regularly is easier with this one.

14 gauge 304 stainless with a #4 brushed finish. That is the standard sanitary look for food, beverage, and pharma spaces where the wireway is exposed, and 14 gauge is a heavy enough wall to keep a 6 inch square body rigid over the 12 inch run without oil-canning.

It carries CSA C22.2 certification, so it is acceptable for work inspected to the Canadian Electrical Code. Order it by manufacturer number 6612-4XSWT if the submittal calls for the certification on record.

Yes. The 4XSWT is a sectional wireway, and a 6 x 6 inch body pairs with other 6 x 6 sections and bodies so the cross-section carries straight through. Keep every joint and connector at the same 4X rating as the trough or the wet-location rating stops at the first unsealed splice.

This is a 4X stainless trough with a seamless poured-in-place gasketed hinged cover, and openings are made in the field to suit the run. Any hole you cut has to be closed with a 4X rated fitting or hub, otherwise the enclosure no longer holds the rating it was built to.