NUVO Lighting 65-830R1 2ft, 20W, LED Tri-Proof Linear Fixture, CCT Selectable, IP65 and IK08 Rated, 0-10V Dimming, 120V-347V

One fixture covers the whole range. The 65-830R1 is rated 120V-347V, so it drops onto 120, 277 or 347 volt circuits with no separate voltage version to specify. That is why it works for a mixed-voltage property where the parking garage is on 347 and the back-of-house is on 120.

Yes. It is rated for outdoor use and carries a Wet location rating, along with IP65 and IK08 ratings, and is cETLus safety listed. That covers car washes, covered loading docks, parking structures and walk-in cooler exteriors where the fixture sees water and knocks.

It is CCT selectable, so the color temperature is chosen at the fixture rather than by ordering a specific Kelvin version. One part number covers every opening in the building and you match existing lighting on site. Output runs 2065 to 2249 lumens depending on the CCT selected, at 80 CRI.

It dims on 0-10V control, which means a low-voltage dimming pair pulled back to a compatible 0-10V driver-rated control. It will not dim on a standard line-voltage incandescent dimmer. If the circuit has no control wiring, the fixture still runs at full output.

Mounting is wall or ceiling surface. The body measures 23.62 inches long, 3.98 inches wide and 3.11 inches high and weighs 2.65 lbs, light enough for standard surface anchors in a garage deck or a block wall.

No lamps to buy. The LED array is integrated into the fixture, so there is no socket, no T8 tube and no ballast. Rated life is 50,000 hours, and when it reaches end of life the whole fixture is replaced rather than relamped. Worth knowing if you are converting from a fluorescent vapor tight that your crew used to relamp.

At 20 watts the fixture puts out 2065 to 2249 lumens depending on the selected color temperature, which is in the range of a two-lamp 2ft fluorescent vapor tight but at a fraction of the draw. For a 2 foot run in a stairwell, cooler or covered dock that is typically a one-for-one swap; for higher mounting heights, plan spacing on the lumen figure rather than the wattage.

The housing is plastic, not metal, which is the usual choice for tri-proof fixtures in damp and chemically aggressive spaces because there is nothing to rust. The IK08 impact rating covers the knocks it takes in a garage or plant aisle.

It is RoHS compliant. It also carries a California Prop 65 disclosure for lead, which is standard for wiring components in many fixtures and matters if you are shipping into a California facility that requires the notice on file.

It is offered in a white and gray finish, a single configuration under part number 65-830R1. There is no alternate color to specify, so repeat orders across a facility all match.