SATCO Lighting S9030 5.5W, A15 LED, Frosted, 2700K, Medium Base, 230 degree Beam Angle, 120V

Yes. The S9030 is an enclosed rated lamp, so a closed globe, flush mount drum, or sealed ceiling fixture is fine. That matters with LED because heat trapped in a non-enclosed-rated lamp shortens life. Burning position is universal, so base up, base down, or horizontal all work.

The S9030 is a dimmable 120V lamp. It is not a three-way bulb, so don't put it in a 3-way socket and expect three light levels. At 0.046 amps draw it's a very small load, so on an older magnetic or incandescent-rated dimmer you'll generally want several lamps on the circuit or an LED-rated dimmer to avoid flicker at the low end.

The S9030 is rated for damp locations and classified as an indoor lamp. A covered porch, a bathroom, or a laundry room is within a damp rating. Do not use it anywhere it will see direct rain or standing water, such as an open soffit-less exterior fixture, since that's a wet location and this lamp isn't wet rated.

2700K is warm white, the same color temperature people associate with a standard incandescent, so it blends with existing incandescent or halogen lamps in the same room. The lens is frosted, which diffuses the diodes so you don't see hot spots through a clear shade, and CRI is 80. Color temperature is fixed, not selectable, so every lamp out of the box is the same 2700K.

Beam spread is 230 degrees, which is an omnidirectional pattern rather than a downward cone. Light goes out to the sides and back past the base, so it fills a shade evenly in a table lamp, sconce, or open fixture the way an incandescent A-bulb does. It's not a spot or flood lamp and won't concentrate light on a surface.

Rated life is 25,000 hours. For a property manager, that's the argument for relamping stairwell, corridor, or vaulted-ceiling fixtures with these instead of 40W incandescents: fewer lift trips, and 5.5W versus 40W on every lamp hour. At 0.046 amps per lamp you can also put many more of them on a single 120V branch circuit than the incandescents they replace.

No. The S9030 is not DLC approved, so it won't qualify for rebate programs that require a DesignLights Consortium listing. It is FCC compliant, and it runs on standard 120V/60Hz power.