Schaub 477 3-1/2" Center to Center Haniburton Cabinet Pull

Yes. The Haniburton 477 is drilled on 3-1/2 inch center-to-center spacing, so it lands on the same two holes as any other 3-1/2 inch ctc pull. Overall length is 4-1/8 inches, so it only adds about 5/8 inch of total footprint beyond the hole spacing, which matters on narrow drawer fronts and stile-and-rail doors.

It is a two-hole cabinet pull, drilled 3-1/2 inches center to center, so it will not work on a cabinet prepped for a single-screw knob. For a single-hole prep, use a knob such as the Orca Hardware Bachelor Collection round cabinet knob at 1-1/4 inch diameter, or the Blackcomb square knob at 25mm.

The Deltana SBP35 Modern Square Bar Pull is a 3-1/2 inch solid brass pull, so it drops into the same two existing holes as the Schaub 477, which is also solid brass on 3-1/2 inch centers. The difference is styling: the Schaub 477 is a transitional Haniburton design with a 1-1/4 inch projection and a 4-1/8 inch overall length, while the SBP35 is a modern square bar profile.

Projection is 1-1/4 inches off the face of the door or drawer, which is enough to get gloved fingers behind the bar. Worth checking against inset cabinet doors near a wall or an adjacent appliance, since the pull stands proud by that full amount when the door is closed.

Six finishes: Satin Nickel, Polished Chrome, Matte Black, Polished Nickel, Satin Brass, and Unlacquered Brass. The Unlacquered Brass is the living finish, it will patina with handling over time, so specify one of the other five if you need every unit in a multi-unit or hospitality job to stay uniform.

Solid brass base material, not zinc die-cast. That matters on a rental or high-turnover kitchen because the mounting boss will not crack at the screw thread the way cast zinc can, and plated finishes over brass hold up better to cleaners.

The 477 Haniburton is a 3-1/2 inch center-to-center pull; the collection is Haniburton, so matching sizes come from within that collection rather than from this single model. If you need a range of ctc sizes in one series for a mixed run of drawers and doors, the Trimco 562 Series drawer pulls are offered in 3-1/2 inch, 4 inch, and 96mm center-to-center, and the Omnia 1968/102 covers 4 inch spacing.

The Omnia 1970 Modern Cabinet Pull is forged solid brass with a 1-1/4 inch projection, matching the 1-1/4 inch projection of the Schaub 477 Haniburton, so finger clearance off the door face is the same. If you can accept slightly less standoff, the Omnia 1969 and Omnia 1971 are both forged solid brass at a 1-3/16 inch projection.

The Schaub 477 Haniburton will not fit a 3 inch bore because it is built to 3-1/2 inch center-to-center. The Trimco 553 Series drawer pulls are made at 3 inch center-to-center for that opening. If you are standardizing a run of cabinets, the Trimco 562 Series covers 3-1/2 inch, 4 inch, and 96mm centers.

The Haniburton is a transitional design, so it reads as a bridge between traditional and modern rather than strictly one or the other. Alongside a purely modern square bar it will look slightly softer. If you want a straight modern bar at the same 3-1/2 inch spacing instead, the Deltana SBP35 Modern Square Bar Pull is a solid brass 3-1/2 inch option.