WAC Lighting 24" Darcy LED Bathroom Vanity or Wall Light WS-38024

Both. The 24-inch Darcy WS-38024 mounts horizontally over a vanity or turned vertically as a wall sconce alongside a mirror, and the mounting method is listed as wall with up/down orientation. The fixture is 24 inches across the long axis with a 23.25 inch backplate, so on a vertical install plan for roughly two feet of clear wall beside the mirror edge.

It dims on an ELV (electronic low voltage) dimmer, and that is the only control type called out for it. A standard incandescent/TRIAC forward-phase dimmer is not the specified control here, so if the bathroom is on an old rotary or slide dimmer, budget for an ELV replacement to get the smooth, flicker-free dimming the fixture is built for.

Yes. The Darcy WS-38024 uses a universal voltage driver rated 120-240-277V, concealed inside the canopy, so the same part number goes into a 120V residential bathroom or a 277V commercial or multi-family lighting circuit without a separate transformer or a different catalog number.

No, not inside the wet zone. The Darcy carries a damp location rating with IP44, which covers a bathroom wall, a covered exterior entry, or a porch, but not direct spray. Keep it out of the shower enclosure and off the wall directly over a tub where water can hit it; use a wet-listed fixture there.

Yes on both. The Darcy WS-38024 is listed ADA compliant and is both Title 24 and Title 20 compliant, which is what a spec on a California job or a public restroom project usually hinges on. It projects 5 inches deep at the fixture height. It is not Energy Star listed.

At 3800 lumens from 34 watts, the 24-inch Darcy puts out enough for task lighting at a mirror, with a flood beam spread and a silk screen tempered glass diffuser that spreads it evenly instead of hot-spotting. Color temperature is 3000K, a warm white that flatters skin tones. For a wide double vanity many designers run two units, one over each sink, rather than a single 24-inch bar centered between them.

There are no lamps to change. The Darcy uses an integrated LED board rated for 50,000 average hours, supplied with the fixture, so there is no socket and no relamping in the maintenance cycle. That matters for property managers and hotel MRO: at end of life the fixture is replaced rather than relamped, so standardizing on one part number across the building keeps the swap simple.

Hardwired only. The Darcy WS-38024 has no cord or plug; it lands on a standard wall junction box with the universal voltage driver hidden in the canopy, and the 23.25 inch backplate conceals the box. Plan for an electrician and a switched circuit, ideally already on an ELV dimmer.

Two: Aged Brass (WS-38024-AB) and Brushed Nickel (WS-38024-BN). Both are 3000K. The body is aluminum with a mitered tempered glass diffuser, so the finish reads on the housing and end caps rather than the lens.