HES 1000-130 KD Filler Plate For D Series Faceplates

No. The 1000-130 is matched to HES D Series faceplates. If your strike uses a different HES faceplate family, or a strike from another manufacturer, this plate is not the filler for it, and you should source the filler listed for that specific faceplate instead.

If the new faceplate is an HES D Series and the leftover cutout sits above or below it, the 1000-130 is the intended cover. It is shipped knocked down and installed in the field. What it will not do is add strength to a butchered frame or reduce the cutout for a faceplate from a different series; in that case you need the correct-length faceplate for the prep, not a filler.

They carry different ratings. The HES 1000-130 filler plate is a Grade 1 commercial accessory, while the Securitron Glass Door Accessories are listed at Grade 2. If a specification calls for Grade 1 hardware throughout an electric strike opening, the 1000-130 meets that line; the glass door accessories are a Grade 2 item for a glass door application rather than a hollow metal or wood jamb strike prep.

Yes. It is a Grade 1, commercial-duty accessory, so it suits the same openings the D Series electric strikes go into: multi-family entries, offices, schools, healthcare corridors. Grade 1 is the heaviest ANSI/BHMA duty tier used in commercial door hardware.

No wiring. The filler plate is a mechanical trim piece that mounts to the frame alongside the D Series faceplate. All the power and monitoring goes to the electric strike itself. If what you need is a powered component, look at items like the Adams Rite 4605 transformer, which converts 115 VAC to 12/24 VAC.

No. The HES 1000-130 is a filler plate for D series electric strike faceplates, an installation accessory that fills unused faceplate cutout area at the strike prep. The Securitron SAM Surface Mount Kit Accessories are mounting components for a SAM surface mount application, not a faceplate filler for an electric strike jamb cutout. If the job is covering leftover jamb prep behind a D series HES faceplate, the 1000-130 is the part; the SAM accessories address a different mounting problem entirely.

They are not interchangeable. The Securitron SWB is a SAM Wood Bracket accessory, a bracket used to mount SAM hardware to wood, while the HES 1000-130 is a filler plate made specifically to work with HES D series faceplates on an electric strike installation. For a jamb already prepped for a D series faceplate, the 1000-130 is the matched accessory; a wood bracket does not register to that faceplate profile.

The 1000-130 does not carry power at all - it is a non-powered filler plate that finishes a D series faceplate opening. If the need is transferring power from frame to door leaf, the RCI 9500/9501 Series Mortise Pin Transfer is the part built for that, rated 1.5A at 24VAC with a tamper-resistant design. Use the 1000-130 for the faceplate cutout and the 9500/9501 for the power transfer; they solve separate parts of the same electrified opening.

They serve unrelated purposes and neither replaces the other. The 1000-130 is a filler plate that finishes out a D series electric strike faceplate installation in the frame. The Dortronics 6510/COV is an anti-tamper alarm cover for 6500 Series pull stations and 5000 Series push buttons, which protects a wall-mounted release device rather than the strike itself. A door could use both, but the filler plate is what addresses the faceplate cutout.