Aurora™ No-Calk® 1-1/2 in.-3 in. Aluminum Solar Flashing 9.5 in. x 12.5 in. Base
Features
- Do not use petroleum based products or paint on flashing collar or plastic base
- Rated 180°F continuous heat and approved for Type B installations
- 1-1/2 in. to 3 in. Aluminum Roof Flashing
- Self-sealing collar slides over pipe and requires no caulking
- For pitch from 0-40°
- Not for hot-mopped or built-up roofs
- For warranty product details, refer to the Oatey Limited Warranty document
- 9.5 in. x 12.5 in. Aluminum base
Manufacturer Resources
Product Specs
- Volume:
- 0.075
- Department:
- Plumbing
- Product Group:
- Roofing
- Product Subgroup:
- Flashing and Flanges
- Product Type:
- Roof Flashing
- Product Finish:
- Unfinished
- Product Material:
- Aluminum
- Product Weight:
- 0.617
OATEY 12804 – Frequently Asked Questions
1) What pipe sizes does the Oatey 12804 solar flashing fit?
The Oatey 12804 Aurora No-Calk flashing covers vent pipe from 1-1/2 in. up to 3 in. The self-sealing collar slides down over the pipe and grips it, so no caulk is needed at the penetration.
2) What roof pitch can this Oatey No-Calk aluminum flashing be installed on?
Pitch range is 0 to 40 degrees, so it covers everything from a dead-flat deck to a steep shingle roof. Above 40 degrees you need a different flashing.
3) Can I use the Oatey 12804 flashing on a hot-mopped or built-up roof?
No. The 12804 is not for hot-mopped or built-up roofs. Asphalt and torch-applied systems are outside what this base is rated for, so specify a flashing intended for BUR on those decks.
4) Is this Oatey flashing OK on a vent from a gas water heater or furnace?
It is rated for 180 degrees F continuous heat and approved for Type B installations, which is what makes it suitable over Type B gas vent as well as standard plumbing vent stacks.
5) How big is the base on the Oatey 12804 roof flashing, and will it tuck under standard shingle courses?
The aluminum base measures 9.5 in. x 12.5 in., which is the common single-shingle-course size for residential vent penetrations. The long dimension runs up the slope so the upper portion slips under the course above and the lower portion laps over the course below.
6) Do I need to caulk or seal around the collar on the Oatey No-Calk flashing?
No caulking at the collar. The collar seals itself against the pipe as it slides on. Just as important, keep petroleum-based products and paint off the collar and plastic base, since they degrade the seal.
7) What is the Oatey 12804 flashing made of, and does it come painted?
The base is aluminum and ships unfinished, so it arrives in bare mill aluminum rather than a color-matched coating. Don't paint it: paint on the collar or plastic base is specifically ruled out by Oatey.
How fast can I get the OATEY 12804 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the OATEY 12804 come with a warranty?
Absolutely. The OATEY 12804 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the OATEY 12804?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the OATEY 12804 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.